Order By Phone 1.855.533.4685 - Mon-Fri 10:30am to 5:00pm

RF Multi Zone Remote and CCT Controller - Cool White and Warm White

CODE: MZCCTCTL

$18.94

In stock

RF Multi Zone Remote and CCT Controller - Cool White and Warm White

The RF Multi Zone Remote and CTT Controller - Cool White and Warm White is to be used with the CCT Adjustable Strip ONLY.  A CCT (correlated color temperature) Adjustable LED Strip allows you to choose the tone of white that your LED Strip will output.


This is it! This is the newest technology to control the degree of white of your whole lighting universe. With the RF Multi Zone Remote and CCT Controller - Cool White and Warm White for Adjustable CCT LED Strips from LED Montreal, you can operate every single CCT Adjustable RF LED Strip in your house. Even if you’re a newbie to all of this, you can start shaping your dream house with the CCT Adjustable Strip kits which includes the remote, CCT controller, 24V transformer and the amount of CTT Strips that you need. Add as many CCT controllers as you want and assign them all to one of the 4 available Zones.

The Multi Zone RF remote operates on 2.4 GHz frequency, giving it a range of at least 20 meters and the RF signal doesn’t require you to point at the CTT controller. The center touchpad gives you control over the brightness of your lighting (up-down) AND the control over the tone of white of your CTT Strip (left-right). You can also assign an unlimited amount of Adjustable CCT LED strips to whichever one of the 4 available Zones. Those items can be synced and controlled together, within the same zone. So if you set 2 x 5 meter bundles on Zone 1, for example, and then turn Zone 1 on with the remote, all your LED Strips will turn on.

The 4 Zone set up is just awesome and so convenient!
A few examples:

  • •    Control the lighting in your kitchen on Zone 1, your bedroom on Zone 2, your living room on Zone 3 and your recreation room on Zone 4.
  • •    Divide a room in two zones and control one side with Zone 1 and the other side using Zone 2.
  • •    Alternatively, you could set up the whole house on a single zone and have all your strips turn on and off in sync... that’s how powerful and versatile this kit is!


Adding on to a Zone is easy!
For a new product or a product that has never been linked before:

  1. Disconnect the power supply from the controller to switch off the light(s) you want to program.
  2. Turn the light back on and within 3 seconds; press the ON (│) button of the Zone you want to assign (1 to 4) on the remote control.
  3. The light will slowly flash 3 times to indicate that it was successfully linked.

You can repeat this procedure for each light product you want to add to a Zone.

Change a light from one zone to another.
If the light you want to add to a Zone was previously assigned to a different one, you will first need to unlink that light.

  1. Identify which Zone the light is currently assigned to.
  2. Disconnect the power supply to turn off the light(s) you want to program.
  3. Power the light back on and within 3 seconds; press the ON (│) button of the previously assigned Zone 5 times quickly.
  4. You can then proceed and program your light according to the add-on procedure outlined above.


For extensive instructions on how to install your Multi Zone setup, VISIT THIS PAGE.
 
As always, our team of experts from LED Montreal is available should you have any question or require assistance putting your project including the RF Multi Zone Remote and CCT Controller - Cool White and Warm White together.

 

Télécommande ou contrôleur RF Multi-Zone - Blanc Chaud et Blanc Froid

No FAQ found, submit a question!

Loading...