Order By Phone 1.855.533.4685 - Mon-Fri 10:30am to 5:00pm

RGB Uncoated IP20 5 meter LED Strip (strip only)



In stock
Quantity  10+   40+ 
Price per unit  $18.90   $15.11 

RGB Uncoated IP20 5 meter LED Strip (strip only)

Cut and reconnect your LED Strips very easily with the RGB Uncoated IP20 LED Strip from LED Montreal! This one is the uncoated version of our famous IP65 LED Strip. Since there is no silicone coating on the strip, the copper connectors are already exposed which makes it so much easier to use with solderless connectors. If you’re looking to cut and reconnect your RGB LED Strips numerous times, this product would make your life a whole lot easier. Plus it’s cheaper!

Please note that since the iP20 strips are uncoated, it is important that they get manipulated gently. Handling them with no care may damage the circuits.

If you need to cut and reconnect, it’s important that you clean off the glue under the strip in order to be able to insert it properly into the solderless connector. For optimal results, brush the extra paint off the copper connectors. For further instructions, please visit the how to use solderless connectors page.

Please note that if you need a more flexible and durable strip, we suggest going with the IP65 LED Strips. 

Use of Adhesive Tape
If you're planning on installing your LED strip sideways or upside down, we strongly suggest using extra adhesive such as the Double Sided 3M 9495LE Tape for LED Strips. For porous surfaces, outdoor usage, wet and marine environments or usage with IP 68 strips, we suggest using the Double Sided 3M Acrylic Tape for LED Strips.

WARNING: Do not use the Double Sided 3M Acrylic Tape on 3014 LED Strips or for more than 4 consecutive hours at full intensity (or commercially used) 5050 Led Strips, as there could be a risk of damage to the LED strip.

The 5050 Strips MUST benefit from proper heat dissipation in order to ensure proper performance and durability. Attempting to install this LED Strip on an improper surface, such as wood or dry wall, will permanently damage the Strip. In order to obtain proper heat dissipation, you must install the 5050 LED Strip in an Aluminum profile or metallic surface.


No FAQ found, submit a question!