120V Connectors and Accessories for RGB LED Strip - 60 LEDs/m

120V Connectors and Accessories for RGB LED Strip - 60 LEDs/m

PLEASE NOTE THAT THESE ACCESSORIES ARE ONLY COMPATIBLE WITH THE RGB 120V LED STRIP. THESE ACCESSORIES WILL NOT WORK WITH 120V SINGLE COLOR LED STRIPS.

LED Montreal offers a variety of accessories and connectors to help you customize your 120V LED RGB Strip project.

Although double sided 3M tape may be sufficient to fasten your RGB 120V LED Strip for most projects, the screw-attached Clips are recommended for installation in areas that are windy, atypical or to solidify installations where 3M double-sided tape is used. Offered in packs of 20, these clips are tailors made for the RGB 120V LED Strip.  

To customize your project and adapt it to your desired measurements, you can cut your RGB 120V LED Strip every 50cm (19 ¾ inch). It is important to safeguard the endings of the LED Strip from the 120V current. The End Caps will permit you to securely shelter your Strip’s end with an aesthetic finishing. We recommend fixing the End Cap with silicon or PVC glue.

The 120V LED Strip Shrink Tube is solid and waterproof. The glue-coated interior which hardens once cooled, provides an incomparable adherence and waterproofing. Install the Shrink Tube on the connection, then heat the Shrink Tube using a heat gun. The Shrink Tube will adjust to the Strip’s diameter within seconds. 

The Strip to Strip Connector will allow you to go around a corner since it is not recommended to bend your LED strip at a sharp angle.

The Infra Red controller for your 120V LED Strip is very useful should you wish to cut your 120V RGB LED Strip, and use the remaining part for another application. The cETLus Listed Waterproof Infra Red controller is rated for outdoor usage. This rugged controller can easily be installed almost anywhere, thanks to its 2 molded brackets. It is preferable to install your controller in an area where the signal of the remote control can reach it as the controller uses infra red technology. Should you choose to install multiple controllers, please be aware that the controllers cannot be synchronized.

As with all high voltage connections, we recommend adding Shrink Tube to secure and seal all joints.  

The accessories can be found in the drop-down menu.