Got a question? Ask Mike!



24V iP20 5m RF Multi Zone 5050 UL Listed RGB+Adjustable White 300 LED Strip Kit

In stock
Add to wish list
Shipping time and rates:
Payment options
Our advantages

24V iP20 5m RF Multi Zone 5050 UL Listed RGB+Adjustable White 300 LED Strip Kit

The base kit includes 1 x 5m cUL listed RGB+CCT White Strip (300 LED), 1x 24V power Supply and 1x RGB+CCt White Multi Zone Controller. You have the possibility of adding a remote control, a Wi-Fi controller or to select a longer kit by using the pull down menu above.

Standard RGB Strips are appreciated because of their wide variety of colors but do tend to cause a slight problem when the time comes to reproducing white.  Since the Standard RGB Strip uses a mix or Red, Blue and Green to makes colors, its version of the color white tends to be very blue or even purple.  

The UL Listed RGB+CCT White Strip kit from LED Montreal will output the full RGB Spectrum PLUS a true White. This chromatic prowess is achieved with special 5050 Chips that integrate 5 separate lights: Red, Green, Blue,  Warm White 2400k and Cool White 6500k. Each Strip features 300 Chips over a span of 5 meters, or if you prefer, 60 LEDs per meters, giving this Strip an amazing brightness, no matter what color you select. The RGB+CCT White Strip will produce any shades of White between 2400k and 6500k, either it be warm white, natural white or cool white or everything in between.

The Multi Zone RGB+White kit can be matched on the same remote as other Multi Zone kits. Simply add it to your set up as you would with any other Multi Zone item: set it on its own zone and you are ready to go. As always, make sure that it’s connected to its own power supply and controller, as the controller has a 6 wire output and the power supply has a 24V output.

Note that the RGB+CCT White is offered in 24V (opposite most Strips that will run on 12V), and that allows you to make a circuit of up to 10 meters in series or 20 meters in parallel. Given that this product runs on 24V, you cannot use a 12V power supply for this Strip or use the provided power supply to try and power up a 12V product. Furthermore, you will notice that this Strip is 12mm wide, therefore wider than the Standard 10mm 5050 Strip. As well, given that this Strip offers RGB and two chips of white, it features 6 connectors unlike the Standard RGB Strip that normally features 4 connectors. This being said, solder less connectors are yet to be made available for this product. Should you require to cut and reconnect your RGB+CCT White Strip, it can be cut every 6 LED et we suggest soldering wires directly on your Strip to advantage of our customization services by calling us to place your order. Minimum fees of 14.95$ + taxes are applicable for each extension installed.


iP20 LED Strip with 3M adhesive
For indoor use only
Certification: UL Listed for Canada and USA
5M roll, 60LED/m. 300 LED total
Can be cut: Every 6 LED (10 cm)
Strip width: 12mm
Power consumption: 14.4W/m at 24V on Multi Zone Controller
Recommended Power: 18W/m at 24V on Multi Zone Controller
Lighting angle: 120 degrees
Luminus flux on white: 400 lm/m
Dimmable: yes through remote control

Professional grade products

Canadian and American Certifications

Quantity discounts available

Create an online quote for your project