24V RGB+White 5m RF Multi Zone 300 LED Strip Kit iP65+

Multi Zone 24V iP65+ RGB+White Strip kit with UL Listed LED Strip

The base kit includes 1 x 5m cUL listed RGB+W Strip (300 LED), 1x 24V power Supply and 1x RGB+White Multi Zone Controller. You have the possibility of adding a wireless wall remote instead or to remove the remote from the kit.

Standard RGB Strips are appreciated because of their wide variety of colors but do tend to cause a slight problem when the time comes to reproducing white.  Since the Standard RGB Strip uses a mix or Red, Blue and Green to makes colors, its version of the color white tends to be very blue or even purple.  

The UL Listed RGB + White Strip kit from LED Montreal will output the full RGB Spectrum PLUS a true White. This chromatic prowess is achieved with special 5050 Chips that integrate 4 separate lights: Red, Green, Blue and White. Each Strip features 300 Chips over a span of 5 meters, or if you prefer, 60 LEDs per meters, giving this Strip an amazing brightness, no matter what color you select. Note that the RGB+W Strip will only produce one shade of White, either it be warm white, natural white or cool white. You will be able to select the white you prefer in the pull down menu when placing your order. Your Strip will produce one color at a time. Therefore, you cannot produce a white and a color at the same time.

The Multi Zone RGB+White kit can be matched on the same remote as other Multi Zone kits and Bulbs. Simply add it to your set up as you would with any other Multi Zone item: set it on its own zone and you are ready to go. As always, make sure that it’s connected to its own power supply and controller, as the controller has a 5 wire output and the power supply has a 24V output.

Note that the RGB+White is offered in 24Vl. Given that this product runs on 24V, you cannot use a 12V power supply for this Strip or use the provided power supply to try and power up a 12V product. Furthermore, you will notice that this Strip is 12mm wide, therefore wider than the Standard 10mm 5050 Strip. As well, given that this Strip offers 4 colors, it features 5 connectors unlike the Standard RGB Strip that normally features 4 connectors. This being said, solder less connectors are not available available for this product. Should you require to cut and reconnect your RGB+White Strip, it can be cut every 6 LED et we suggest soldering wires directly on your Strip.

Specifications:

iP65+ LED Strip with 3M adhesive
Certification : UL Listed for Canada and USA
5M roll, 60LED/m. 300 LED total
Can be cut: Every 6 LED (10 cm)
Strip width: 14mm
Power consumption: 9.6W/m at 24V on Multi Zone Controller
Recommended Power: 12W/m at 24V on Multi Zone Controller
Lighting angle: 120 degrees
Luminus flux on white: 400 lm/m
Dimmable: yes through remote control