24V 5m iP20 RGB+W 5050 LED Strip - 96 LEDs/m (Strip Only)

Standard RGB Strips are appreciated because of their wide variety of colors but do tend to cause a slight problem when the time comes to reproducing white. Since the Standard RGB Strip uses a mix or Red, Blue and Green to makes colors, its version of the color white tends to be very blue or even purple.

The cUL Certified RGB + White Strip kit from LED Montreal will output the full RGB Spectrum PLUS a true White. This chromatic prowess is achieved with special 5050 Chips that integrate 4 separate lights: Red, Green, Blue and White. Each Strip features 480 Chips over a span of 5 meters, or if you prefer, 96 LEDs per meters, giving this Strip an amazing brightness, no matter what color you select. Note that the RGB+W Strip will only produce one shade of White, either it be warm white (3000K), natural white (4000K), cool white "Daylight" (5000K). You will be able to select the white you prefer in the pull down menu when placing your order.

When used with the Multi Zone system, your Strip will produce one color at a time. Therefore, you cannot obtaine a white and a color at the same time. This limits the Strip's consumption to 15.36W/m. We then recommend using 19.2W/m on your power supply.

When used with the WL5 - 5 in 1 Wi-Fi Controller, you will be able to mix the white and the colors in order to obtain a more pastel shade. At that point, we recommend using 28.8W per meter for your power supply.

This iP20 LED Strip does not offer any water protection. iP20 strips are ideal for indoor usage in aluminium profiles.

Note that the RGB+White Strip is offered in 24V (opposite most Strips that will run on 12V), and that allows you to make a circuit of up to 10 meters in series. Given that this product runs on 24V, you cannot use a 12V power supply for this Strip. Furthermore, you will notice that this Strip is 12mm wide, which is wider than the Standard 10mm 5050 Strip. As well, given that this Strip offers 4 colors, it features 5 connectors unlike the Standard RGB Strip that normally features 4 connectors. This being said, solderless connectors are yet to be made available for this product. Should you require to cut and reconnect your RGB+White Strip, it can be cut every 6 LED (6.2cm) and we suggest soldering wires directly on your Strip to advantage of our customization services by calling us to place your order. Minimum fees of 15.95$ + taxes are applicable for each extension installed.

Strip Features:

Brand: CDNLUX
Model: MTL-FP12AGIDJ-96ARGBW
Certification: cULus E498952
Available voltage: 24V DC
Chip: 5050 RGB SMD 5 in 1
Roll 5m, 96LED / m. 480 LEDs in total
Lighting angle: 120 degrees
Can be cut: Every 6 LEDs (6.2cm)
Ribbon Width: iP20: 12mm
Total height: 2mm
Self-adhesive, 3M sticker
Luminus flux on white: 640 lm/m
Dimmable: Yes through remote control
Power Consumption:    15.4W/m at 24V on Multi Zone Controller
         23W/m at 24V on 5 in 1 RF Multi Zone Controller
Recommended Power: 19.2W/m at 24V on Multi Zone Controller
             28.8W/m at 24V on 5 in 1 RF Multi Zone Controller
Must be powered by a class 2 transformer (Under 96W)
Operating temperature: 40° C to -10° C
IP20, unprotected: Suitable for dry environments
Heat dissipation: recommended

RGBW-24V-5050-LED-Strip-EN-CDNLUX.pdf