24V 5m iP67 RGB 5050 Super Bright Weatherproof LED Strip - 60 LEDs/m (Strip Only)
24V 5m iP67 RGB 5050 Super Bright Weatherproof LED Strip - 60 LEDs/m (Strip Only)
LED Montreal offers you a simple and affordable way to color up your environment with the 24V DC 5m iP67 RGB 5050 LED Strip. The waterproof iP67 coating offers a great protection against temporary water exposure although the Strip should never be submersed in liquid or permanently be exposed to wet conditions. This Strip is equipped with a strong 3M adhesive.
The technical stuff: RGB Stands for Red-Green-Blue. 5050 RGB Chips give a 120-degree light beam and feature each of these 3 colors of LED lights within each chip: This allows to create up to two million different colors by mixing the red, green and blue at different levels. The amount of colors that can be achieved will depend on the RGB controller that you use. Note that the RGB Chip does not create a true white. Should you want to use your Strip to both enhance your décor and get an ambient white light, we strongly suggest using our iP67 RGB+W that includes a white LED diode within the 5050 chips.
RGB LED Strips have a 4-wire connection, meaning that they can only be operated through a RGB controller and a remote or wall panel remote. The remote will allow you to dim your strip and change colors manually or through automated color change patterns. The strip cannot be dimmed through a standard wall dimmer. Forecast a power supply at 24V DC of 18W (0.75A) per meter for your installation. As stated earlier, this strip comes in a 5m spool. You will find all the specs of the RGB LED Strip at the bottom of this page.
You can customize your LED Lighting set up as this Strip can be cut every 6 LEDS. The RGB LED Strip is flexible vertically but cannot be bent horizontally. Should you need to bypass an obstacle or turn a corner, we recommend removing the iP67 sleeve with an x-acto knife and solder 4 strand wire onto your Strip. Soldering ensures a solid connection and minimal voltage loss.
Your RGB LED Strip is equipped with a high-quality 3M adhesive. This adhesive is intended for installation on a clean, non-glossy metallic surface. LED Strips were not designed to be installed on varnished or glossy wood surfaces. For porous surfaces we suggest using the Double Sided 3M Acrylic Tape for LED Strips. LED Strips are electronic devices, we do not suggest using them for boats, vehicles or near bodies of water.
Specifications:
Brand: CDNLUX
Model: MTL-FP10AGIWM-60ARGB
Certification: cULus for Canada and USA
Chip: Epistar 5050 RGB SMD
Chip density:Â 60 LEDs per meter
Can be cut:Â All 6 LEDs (100mm)
Length: 5 meters
Width: 12mm
Height: 6mm
Voltage: 24V DC
Power consumption: 14.4W/m
Recommended power supply: 18W/m, Class 2 power supply required
Recommended power supply for 5m:Â 96W, Class 2 power supply required
Available colors: RGB (Red, Green, Blue)
Lighting angle: 120°
Lifespan: 50 000 Hours
Self-adhesive: 3M
iP rating: iP67
Suitable environment: Suitable for dry, humid environment. Indoor and protected outdoor use.
Operating temperature: 40C to -10C
Connections included: 4 pin male connector (17cm) on one end and 4 pin female connector (17cm) on the other end
Dimmable: Yes, with a low voltage controller/remote combo
Heat dissipation: Not necessary, unless used in a commercial environment
