K2 Kit. 1 Zone RF Removable Magnetic Wall Remote + E2-RF Controller
K2 Kit. 1 Zone RF Removable Magnetic Wall Remote + E2-RF Controller
You can now remotely dim your Single-Color LED Lights with this Control Kit that includes both the rotating wall remote and the controller.
This kit allows you to dim your LED kit without having to install a dimmable power supply or worry about wall or furniture interfering with the remote signal.
Your remote uses 2.4GHz radio frequencies to achieve an amazing 30m of range through walls and floors. This means that you can hide your controller in your TV stand and still be able to control your LED Strips or your Low Voltage LED Pucks.
Although this remote is a 1 Zone product, it allows you to pair an infinite amount of controllers (other controllers sold seperately) to your Zone. You could use several power supplies and controllers for your under-cabinet lighting and they would all be controlled by the same remote, as if everything was one big set up !
Looking to control several set ups from a single wall panel? Have a look at the 4 Zone panel from LED Montreal.
The main control components to your Wall Remote:
- On/Off Button
- Brightness Dimming: This feature is available with all types of Single Color LED Strips, when you wish to lower the intensity of your LED Strip.
- Color temperature (CCT): Used with Adjustable White Strips. Gives you the possibility to change the color temperature from warm white to cool white or any type of white in between.
To set up the output mode:
Press the "SET" button continuously to switch the output mode. The controller will log out if there's no operation within 3 seconds. Output modes are indicated by the color of the indicator light.
Red Light: Single Color
Green Light: CCT Adjustable White
Linking Code Instructions:
1. Connect your LED strip and transformer to the controller. Make sure the Strip turns on, then briefly press the SET button on the controller.
2. Briefly press the SET button on the back of the K2 3 times within 3 seconds.
3. The lights will flash slowly 3 times to indicate a successful connection.
4. If the connection fails, repeat the steps.
Unlinking Code Instructions:
1. Turn off for 10 seconds by unplugging the transformer, then plug it back in.
2. Briefly press the SET button on the back of the K2 5 times within 3 seconds.
3. The lights will flash rapidly 10 times to indicate a successful disconnection.
4. If the disconnection fails, repeat the steps.
Attention:
Turn off the power supply before installation.
Ensure the input voltage matches the device requirements.
Avoid using the device in areas with large metal surfaces or strong electromagnetic waves, as this may affect the remote distance.
Specs Wall Panel Remote:
Model: K2
Voltage: 3V CR2032 battery (Included)
Transmission Frequency: 2.4GH
Control Distance: 30m
Dimensions: 86mm x 86mm x 22mm
Specs Controller:
Model: E2-RF
Input Voltage: DC12~24V
Output: 6A/Channel
Total Output: Max 12A (4A at 24V or 5A at 12V to comply with Class 2 requirements)
RF: 2.4GHz
Control Distance: 30m
iP Rating: iP20
Working Temperature: -10~40°C
Output Connection: Common anode
Dimensions: 100.6mm x 40mm x 17.6mm
