12V Bendable Super Bright 5050 RGB 210 LED Strip Kit
12V Bendable Super Bright 5050 RGB 210 LED Strip Kit
The LED Strip and the power supply in this kit are cUL Listed
Always wanted to backlight letters or oddly shaped objects but regular LED Strips would not do the trick? Well, your search is over with the new 12V Bendable 5050 RGB 210 LED Strip Kit from LED Montreal. Thanks to its unique M shape PCB, this 12V LED Strip can be twisted to just about any shape. Offered in 5 m length, the Strip can be cut at every 3 LED (7.2cm) to perfectly fit your project. The Bendable 12V RGB Strip features authentic high performance Epistar chips that provide a light up to 50% brighter than standard RGB Strips.
To ensure high flexibility, this LED Strip does not come with a silicone coating and should only be used indoors. Should you need to connect letters together, we recommend soldering multi braid RGB wire on the exposed copper connections. There are no quick connectors available for this product. You should not connect 2 strips in series and the maximum amount of wire used for a single circuit has to be under 4 m total. Using a Dimmer is optional
Do not need a multicolor display? The Bendable LED 12V LED Strip is also available in Single Color.
The kit includes everything you need to use your cUL Listed 12V Bendable 5050 RGB 210 LED Strip: The RGB controller, a 12V 6A cUL Listed power supply and your choice of a remote control, a wall panel for $10 extra or simply no remote for $25 less. Note that the “no remote” option should only be used if you already have a remote for a Multi Zone system.
Specifications:
iP20 LED Strip with 3M adhesive
For indoor use only
Certification: cULus
Width: 12mm Height 1.7mm
5M roll, 42 LED/m. 210 LED total
Can be cut: Every 3 LED (7.2 cm)
Required Power: 9W/m at 12V
Recommended Power: 11W/m at 12V
LED Type: Epistar 5050 SMD, 42LEDS per meter
Lighting angle: 120 degrees
Typical light output: Red 620-625nm Green 515-520nm Blue 465-470nm
Cuttable: every 3LED (7.2cm)
Maximum Length per power supply: 10m in parallel (5m on each side of your Power supply)
Waterproofing available: iP20
Dimmable: Through remote control only
Heat sink: highly recommend
Applications: Mainly used for indoor signage or backlighting logos and letters thanks to its unique M shape PCB.
Use of Adhesive Tape
We do not recommend sticking this product to wood surfaces. We suggest using a proper metallic surface to ensure proper heat dissipation. Improper heat dissipation may result in shorter lifespan, discoloration and/or great loss of brightness of your LED Strip.
